By avoiding the use of adhesives, we prioritize your health, creating a pristine detox environment that nurtures and rejuvenates. Our unique construction techniques ensure unmatched quality, offering a sanctuary with low Electric and Magnetic Fields (EMF/ELF).

• Non-Resinous Canadian Hemlock
• Far Infrared low EMF carbon heaters (120V, Dedicated 20 Amp, Standard Plug)
• 8mm Tempered Glass
• Interior Lighting
• 640 pounds + traditional heater and stones
• Easy Assembly
  • The sauna is easily assembled with 2 people, but the front wall with the glass door and window is heavier and might require extra hands to get to the desired location
  • Electrician required for Traditional Heater Installation
• Harvia KV 60 Traditional Heater with Sauna Rocks included (220V 30 Amp Electrician Required)

• Exterior: 59 in. Width / 43 in. Depth / 84 in. Height
• Interior: 55 in. Width / 39 in. Depth / 71 in. Height
• Weight: 640 pounds + traditional heater and rocks

Infrared Heaters:

• 120V
• Dedicated 20 Amp
• Standard US 20 Amp 3-prong plug

Traditional Heater:

• 240V
• Dedicated 30 Amp
• Electrician Required
  • Harvia KV-60-S (controls built on heater)
  • KV60 needs a 2 pole 30 amp non-GFCI breaker.
  • Run (2) #10 copper wires + ground to heater.
  • Wires connect to heater terminals 1 and 2.  
  • Make sure to run the thermostat wire up the face of the sauna wall.  Sensor mounts a foot down from the ceiling and about a foot away from the side of the heater.

• The Sauna ships in 12 pieces: Front Wall, Back Wall, Side Wall (2), Floor, Ceiling, Bench (2 Pieces), Roof (4 Pieces).
• The walls fit together around the floor with tongue and groove and are then secured with 5 screws in pre-drilled holes.
• The bench slides in using wooden notches.
• The ceiling slides into place once the walls are secured
• Corresponding electrical components are connected on top of the cieling.
• The roof comes in 4 pieces. Two support pieces are attached on the front and back of the sauna with screws in pre-drilled holes. The actual shingled roof (2 pieces) is placed on top and attached with screws through pre-drilled holes. Extra provided shingles are attached to the top of the roof.
• Once the Sauna is built, your electrician will install the traditional heater and your sauna is ready for use!
• To disassemble you follow the same steps in reverse. The traditional heater will need to be disconnected before disassembling the sauna.

Sauna and Heater: 4 Years

To order you pay the deposit through the button below. Once your sauna is ready to ship, you will be charged the remainder of the balance and then your sauna will ship to you. It will arrive in 12 pieces that you move individually to where you plan to assemble the sauna.

You will be sent heater installation instructions. Make sure to send them to your electrician. Once you assemble the sauna and the traditional heater is installed, your sauna is ready for use!